Difference between revisions of "KiSS Commander"

From KiSS DP 558 STAGE2 WiKi
Jump to: navigation, search
(Created page with "== Kiss Commander == ===== Features: ===== * manage files directly on Kiss HDD * manage processes on Kiss * display memory usage on Kiss Kiss Commander needs telnet connect...")
 
(Features:)
Line 38: Line 38:
  
 
*PLEASE* be aware that this is test and incomplete version !
 
*PLEASE* be aware that this is test and incomplete version !
 
+
*WARNING*: This software is provided 'as-is', without warranty of any kind,either expressed or implied. In no event shall the author be held liable for any damages arising from the use of this software.
 
 
**WARNING**: This software is provided 'as-is', without warranty of any kind,
 
            either expressed or implied. In no event shall the author be held liable for any damages arising from the use of this software.
 
  
  
 
Antonio Bakula, 02.11.2005
 
Antonio Bakula, 02.11.2005
 
e-mail: antonio@antoniob.com
 
e-mail: antonio@antoniob.com

Revision as of 20:56, 8 February 2012

Kiss Commander

Features:
  • manage files directly on Kiss HDD
  • manage processes on Kiss
  • display memory usage on Kiss

Kiss Commander needs telnet connection to Kiss to work. Please enter Kiss IP address and telnet port number on startup. KissCommander runs on windows, it was tested on Windows XP SP1, and Windows 98.




Kiss Memory :

Every instance of Kiss Commander will consume another 1200 kb of Kiss memory. And if your Kiss runs out of memory it will chrash, so be carefull ! You can check free memory with telnet connection and command Free. If you disable memory checking in setup (enter 0 in Refresh Free Memory info rate) Kiss Commander wil consume 600 kb, but if you press CTRL+M (shortcut for Refresh now) memory consumption will raise again on 1200 kb. In short for "free memory info" command Kiss Commander uses another telnet connection, and every telnet connection consumes aproximatly 600 kb.



Running Processes:

Do *NOT* kill processes on Kiss unless you are sure what you are doing ! Kiss Commander uses two lash processes (if memory info enabled) and if you kill one of this two processes it will stop working properly.

Report any problems to project issue tracking system at : http://www.antoniob.com/mantis


  • PLEASE* be aware that this is test and incomplete version !
  • WARNING*: This software is provided 'as-is', without warranty of any kind,either expressed or implied. In no event shall the author be held liable for any damages arising from the use of this software.


Antonio Bakula, 02.11.2005 e-mail: antonio@antoniob.com